The use of fishing rod need to pay attention to maintenance matters

The maintenance of the fishing rod should be the routine work of the fisherman. The rods should be well-maintained to prevent skin blemishes, scratches, cracks or peeling of the patent leather. Therefore, to prevent the fish from ageing and deteriorating, life is extended. What's more, the maintenance of fishing rods is an enjoyment for fishermen. The so-called maintenance is the timely protection and proper maintenance. From the new arrivals to the hands to the use of every time, the maintenance work of the fishing rod is always running through. Here are some precautions for maintaining the fishing rod:

 

When fishing, remove the jacket and pull it straight out. Hard twisting and twisting will cause the end of the knot to break, causing damage to the fishing rod. When starting the fishing stroke, align the front and rear wire loops. Otherwise, the main wire may become entangled or the tail tip may break. Do not wind the main thread wound into a knot to prevent it from breaking. You should try your best to use the pendants as required, and do not let the tail end be overstressed. If there is a hang-up in the course of fishing, you must not use too much force to carry out hard digging, and most of the consequences will end with a breakdown. When fishing in the sand, care should be taken to prevent sand from entering the knots and the fish wheel, which should be supported by trusses or other objects. Fishing should be over-excited when it comes to big fish, and it can be used with big fish. Otherwise, there will be regrets of breaking fish and running fish. When you need to change the position during the fishing process, you must shrink the fishing rod and then climb the mountain, over the water, and wear the forest. This will prevent breaks and other inconveniences. Be sure not to use stretching to replace the extension at the beginning of use, otherwise it will cause "dead days." In the shore and boat fishing, the dumping must be taken care of before and after the first look to prevent injury to people.

 

The second step is to use a clean and soft towel (not a wet towel) to wipe the rod several times after using the rod, because if there is moisture in the rod, it will erode the paint of the rod and then it will cause the fish to come off. Paint and air bubbles need to be wiped clean with a towel after going home, dried in a cool place, and sealed with a special rod. If you don't use your home for a long time, it is recommended that you regularly take out some lubricant (or mechanical oil) on the contracted part of the fishing rod and store it in a dry place.

 

I believe that fishing-loving friends can do a good job for the long-term maintenance of fishing rod equipment, and moderate maintenance work will also extend the life of the fishing rod.